6.
Removal of Cooktop from Bench/Counter-Top
It is probably easiest to service the internal components (gas valves, electronics) by removing
the top panel rather than removing the product from the bench (see Section 4).
6.1 To Remove the Product from the Bench/Counter-Top
Disconnect the electrical supply.
Turn off gas supply and disconnect.
Loosen the clamping brackets at the front/sides (underneath).
Lift product out.
Note: Fit
a
new
(Part number 530132). Tighten the floating nut to firm finger tight plus
of rotation).
7.
Replacement & Servicing of Electronic Ignition
7.1 To Replace an Electrode
Disconnect from power.
Remove the product top panel - (see Section 4).
Unlatch the appropriate locating spring and remove the electrode. Replace
Reassemble in reverse order.
7.2 To Replace Ignition Box
Disconnect from power.
Remove the product top panel - (see Section 4).
Unplug the electrodes and the multiway plug from the ignition box.
Replace the box. The ignition box is held down by double sided foam tape.
For the auto re-ignition box.
Electrode wires must be plugged into correct terminals. Terminal Numbers on the ignition box
correspond to:
#1:
Front left burner
#2:
Front right burner
#3:
Middle burner
#4:
Rear left burner
#5:
Rear right burner
Reassemble in reverse order.
blue
sealing
washer
when
re-connecting
- 12 -
the
gas
supply.
/
of a turn (90°
1
4