Whirlpool Rooper Service Manual page 33

6. Bend the bracket up just far enough to access
the hot surface indicator, then press the two
locking arms against the indicator body, and
unsnap it from the bracket.
7. Cut the white and black wires coming from the
old hot surface indicator, and splice the wires
to the same color wires of the new indicator
with twist-on connectors.
BEND
BRACKET UP TO
ACCESS INDICATOR
MAINTOP
BRACKET
UNSNAP LOCKING
ARMS FROM
BRACKET
TWIST-ON
CONNECTOR
HOT SURFACE
INDICATOR
WIRES
WHITE
WIRE
HOT SURFACE
INDICATOR
Cooking Products Service Manual
Original July, 1996
© 1996 Whirlpool Corporation
8. Snap the new hot surface indicator into the
bracket hole and bend the bracket back into
place.
9. Reinstall the maintop and reassemble the
range. REASSEMBLY NOTE: When reinstall-
ing the maintop, make sure that it is centered
on the range, that the side brackets are en-
gaged, and that the rear side flanges are
inside the end caps.
BLACK
WIRE
3-7
4321892
Page 3-7