4.2 Creating New Group and Gateway
2. Setup Wizard (1/6):
a.
Enter Name of the Gateway.
b.
Select "BV1250G" for "Unit", "V1.40" for
"Version", and "BRIT" for "Interface".
Note: Do not select any other value than
above.
c.
Enter Comment for the Gateway (if
necessary), then click [Next >].
3. Setup Wizard (2/6):
Enter IP Address, Subnet Mask, and Route
Address of the Gateway, then click [Next >].
Consult your network administrator for
specific values.
4. Setup Wizard (3/6):
Enter "Call control signal TCP port no."
(default: 1720), then click [Next >].
Consult your network administrator for
specific values.
5. Setup Wizard (4/6):
•
Check "Use Default Password" to accept
the default Maintenance Level Password
("mainte"), then click [Next >].
•
Enter and confirm the Maintenance Level
Password to change the default
password, then click [Next >].
Getting Started
25