Cable Connection; Rs-232C Cable Connection; Base-T Cable Connection - Panasonic KX-TDA0480 Getting Started Manual

2.2

Cable Connection

2.2.1 RS-232C Cable Connection

To initialise a newly installed IP Gateway Card using the Maintenance Console Software (see
4.2 Creating New Group and Gateway), a computer or terminal must be connected directly to
the unit using an RS-232C serial (cross) cable with DB9 Female to DB9 Female connectors.
1.
Turn the computer power OFF.
2.
Connect the RS-232C cable to one of the PC's COM ports (e.g., COM 1) and to the Serial
Port connector on the IP Gateway Card front panel.
COM port on the PC
Circuit Type (EIA)
AA
BA
BB
CA
CB
CC
AB
CF
CD

2.2.2 10 Base-T Cable Connection

A standard 10 Base-T cable with an RJ-45 connector is used to interconnect the IP Gateway
Card with a network device.
1.
Insert the RJ-45 connector into the IP Gateway Card Uplink port located on the IP Gateway
Card front panel.
2.
Connect the other end of the 10 Base-T cable to the remote LAN equipment.
PC
When connecting the Hybrid IP-PBX directly to a router or PC, use a 10 Base-T Cross/Rollover
cable. Use a 10 Base-T straight cable to connect the Hybrid IP-PBX to a switching HUB.
RS-232C Serial Cable (Cross cable)
To COM port
PC
Signal Name Pin No.
FG
1
SD (TXD) 2
RD (RXD)
3
RTS
4
CTS
5
DR (DSR)
6
SG 7
DCD 8
ER (DTR)
20
Router
Switching HUB
or
10 Base-T cross cable (Rollover)
or
Router
To IP Gateway Card
RS-232C port
Hybrid IP-PBX
RS-232C port on the IP Gateway Card
Pin No.
Signal Name
RI
9
2 RXD
TXD
3
RTS
7
CTS
8
DTR
4
5 SG
6 DSR
DCD
1
10 Base-T straight cable
2.2 Cable Connection
Circuit Type (EIA)
CE
BB
BA
CA
CB
CD
AB
CC
CF
Hybrid IP-PBX
Getting Started 13