Installation; Rear Cargo Lamp Removal; Rear Cargo Lamp Unit Removal - Chrysler PT Cruiser Service & Repair Manual

8L - 32 LAMPS/LIGHTING - INTERIOR
CLUSTER ILLUMINATION LAMPS (Continued)
other indicators are burned out, the entire cluster
must be replaced.
The cluster illumination bulbs are serviceable and
may be replaced once the instrument cluster is
removed (Refer to 8 - ELECTRICAL/INSTRUMENT
CLUSTER - REMOVAL).
Fig. 8 INSTRUMENT CLUSTER ILLUMINATION
1 - HIGH BEAM INDICATOR
2 - ILLUMINATION BULBS

INSTALLATION

The illumination bulbs (Fig. 8) are serviceable. The
bulb and socket turn in clockwise. Then the instru-
ment cluster may be installed (Refer to 8 - ELECTRI-
CAL/INSTRUMENT CLUSTER - INSTALLATION).
After servicing the indicator (high beam only),
install the instrument cluster (Refer to 8 - ELECTRI-
CAL/INSTRUMENT CLUSTER - INSTALLATION).
After replacing the turn signal bulb(s) (Fig. 7),
install the (Refer to 23 - BODY/INSTRUMENT PAN-
EL/CLUSTER BEZEL - INSTALLATION).
REAR CARGO LAMP
REMOVAL
(1) Open liftgate.
(2) Remove jack storage door from right rear quar-
ter trim panel.
(3) Remove jack and tool bag.
(4) Place right hand on stem of cargo lamp unit
and pull downward until lens separates from the
lamp unit (Fig. 9).
(5) Pull cargo lamp unit through jack storage door
opening to access bulb.
(6) Disconnect wire connector from cargo lamp
unit.
(7) Pull bulb from unit socket.
INSTALLATION
(1) Push bulb into unit socket (Fig. 9).
(2) Snap lens onto lamp unit.
(3) Move wire connector through lamp opening and
connect wire connector to cargo lamp unit.
BULBS
Fig. 9 REAR CARGO LAMP
1 - JACK STORAGE AREA
2 - WIRE CONNECTOR
3 - CARGO LAMP UNIT
4 - BULB
5 - LENS
(4) Place cargo lamp unit into opening and apply
hand pressure to seat lamp unit into rear quarter
panel.
(5) Install jack and tool bag in the storage area.
(6) Install jack storage door to the right rear quar-
ter trim panel.
(7) Close liftgate.
REAR CARGO LAMP UNIT
REMOVAL
(1) Open liftgate.
(2) Remove jack storage door from right rear quar-
ter trim panel.
(3) Remove jack and tool bag.
(4) Place right hand on stem of cargo lamp unit
and pull downward until lens separates from the
cargo lamp unit (Fig. 9).
(5) Pull cargo lamp unit through jack storage door
opening to access bulb.
(6) Disconnect wire connector from cargo lamp
unit.
(7) Remove cargo lamp unit from vehicle.
INSTALLATION
(1) Snap lens onto lamp unit (Fig. 9).
(2) Move wire connector through lamp opening and
connect wire connector to cargo lamp unit.
PT