Site Selection and Preparation
spacers. Do not install the
fireplace insert directly on
carpet or similar surfaces
which may restrict air
circulation. If installing the
fireplace in a carpeted area,
place a one-piece, solid flat
surface under the fireplace.
Ensure that all feet rest
securely on this surface.
Figure 1
22 ⅞"
(580 mm)
Fireplace Installation
Fireplace Assembly
Depending on the unit, the
front glass will come packaged
separately or installed in the
firebox.
1.
remove fireplace and glass
(if not already installed)
carefully from the carton,
discard the plastic bag and
foam packaging.
8
27 ⅜"
(695 mm)
!
NOTE: The dimensions of the
fireplace with the trim are 27 ⅜"
(695 mm) wide X 23 ½" (596 mm)
high X 8 3/4" (222 mm) deep.
Dimensions without trim are
26 ¼" (663 mm) wide X 22 ⅞"
(580 mm) high X 8 ¾" (222 mm)
deep. The fireplace does not
require any additional venting
(Figure 1).
23 ½"
(596 mm)
2.
Remove the right hand side
trim by removing four (4)
Phillips screws at the side of
the fireplace. (Figure 3)
3.
remove the front glass, if
necessary
4.
remove the foam block from
within the fireplace (Figure 2).
5.
using side cutters or scissors,
cut and remove the two (2)
26 ¼"
(663 mm)
www.dimplex.com
8 ¾"
(222 mm)