Table of Contents
Advertisement
8. vENTILATION SySTEM
This Microwave Oven/Hood System is designed for adapta-
tion to three types of hood ventilation systems. Select the
type required for your installation.
A. Recirculating — Non-Vented, ductless
Operation
The unit is shipped assembled for recirculating.
Notes:
1. The Exhaust Damper Assembly is not required for recir-
culating operation.
2. The Charcoal Filter should be replaced every 6 to 12
months, depending on use.
B. Horizontal Exhaust — Outside Ventilation
1. Remove and save the 4 screws from Fan Cover Bracket.
Remove Fan Cover Bracket by sliding it in the opposite
direction of the arrow on the Fan Cover Bracket, as
shown in Figure 7.
2. Lift Hood Fan Unit carefully and slip wires out of cavity.
See Figure 8.
CAUTION: Do not pull or stretch hood fan wiring.
3. Rotate the Hood Fan Unit 180˚ so that the fan blade
openings are facing the back of the oven. Note, you will
need to lift the wire over the hood fan unit so the wire
will clear. See Figure 9 (A). Replace Hood Fan Unit into
the oven. Be careful not to pinch the wire and the Hood
Fan Unit. See Figure 9 (B).
4. Put the wire back into the cavity.
5. Replace the fan cover bracket. Make sure the fan blades
are visible through the rear openings in oven before
proceeding. Attach the fan cover bracket to the unit
with the 4 screws removed in step 1 above. See Figure
10. The hood fan is now rotated for horizontal exhaust
operation.
6. Attach the Exhaust Damper Assembly to the back of the
mounting plate by sliding it into the slits in the same di-
rection as the arrow. See Figure 11. Using tapping screw
4 x 12 mm from the INSTALLATION HARDWARE, tighten
into place.
4
Fan Cover Bracket
Figure 7
Figure 8
(A) Rotate 180˚
(B)
Figure 9
Wire Box
Figure 10
Mounting Plate (back side)
Figure 11
Advertisement
Table of Contents
