GMC 2011 Canyon Owner's Manual page 158

7-8 Infotainment System
To scan preset stations, press
and hold SEEK for more than
four seconds until two beeps sound.
The radio goes to the first preset
station, plays for a few seconds,
then goes to the next preset station.
Press SEEK again to stop
scanning presets.
SEEK : Press to go to the next
station and stay there.
To scan stations, press and hold
SEEK for two seconds until a
beep sounds. The radio goes to a
station, plays for a few seconds,
then goes to the next station. Press
SEEK again to stop scanning.
To scan preset stations, press
and hold SEEK for more than
four seconds until two beeps sound.
The radio goes to the first preset
station stored on the pushbuttons,
plays for a few seconds, then goes
to the next preset station. Press
SEEK again to stop scanning
presets.
Radio with CD (MP3/WMA)
BAND: Press to switch between
FM1, FM2, AM, or XM1 or XM2
(if equipped). The selection
displays.
TUNE : Turn to select radio
stations.
SEEK : Press to go to the
previous or next station and stay
there.
SCAN : Press and hold for
more than two seconds, SCAN
displays and the radio beeps once.
The radio goes to a station, plays
for a few seconds, then goes to the
next station. Press or
stop scanning presets.
To scan preset stations, press
and hold or for more than
four seconds, PSCN displays and
the radio beeps once. The radio
goes to a preset station, plays for a
few seconds, then goes to the next
preset station. Press or
to stop scanning presets.
I n f o r ma t i o n P r o v i d e d b y :
Radio Data System (RDS)
The Radio with CD (MP3/WMA)
has an RDS system. RDS features
are available for use only on FM
stations that broadcast RDS
information.
With RDS, the radio can do the
following:
Seek to stations broadcasting
the selected type of
programming.
Receive announcements
concerning local and national
emergencies.
Display messages from radio
again, to
stations.
Seek to stations with traffic
announcements.
again,