GMC 2011 Canyon Owner's Manual page 102

3-58 Seats and Restraints
3. Tighten the lower anchor
attachments and the top tether.
The child restraint instructions
will show you how.
4. Before placing a child in the
child restraint, make sure it is
securely held in place. To check,
grasp the child restraint at the
LATCH path and attempt to
move it side to side and
back and forth. There should
be no more than 2.5 cm (1 in)
of movement, for proper
installation.
Front Seat Regular/
Extended Cab without Rear
Seats
The vehicle has a right front
passenger airbag and may also
have a passenger sensing system.
If the vehicle has a passenger
sensing system it is designed to
turn off the right front passenger
frontal airbag when an infant in a
rear-facing infant seat or a small
child in a forward-facing child
restraint or booster seat is detected.
See Securing Child Restraints (Rear
Seat Position) on page 3 60 or
Securing Child Restraints (Center
Front Seat Position) on page 3 62
or Securing Child Restraints (Right
Front Seat Position) on page 3 63
and Passenger Sensing System on
page 3 34 for important safety
information and additional
information on installing a child
restraint in the right front seat
position.
1. See Securing Child Restraints
(Rear Seat Position) on
page 3 60 or Securing Child
Restraints (Center Front Seat
Position) on page 3 62 or
Securing Child Restraints
(Right Front Seat Position) on
page 3 63 for instructions on
installing the child restraint using
the safety belts.
I n f o r ma t i o n P r o v i d e d b y :
2. If the child restraint
manufacturer's instructions
recommends that the top tether
be attached, attach and tighten
the top tether to the top tether
anchor. Refer to the child
restraint instructions and the
following steps:
2.1. Pull the seatback forward
to access the top tether
anchor. See Seatback
Latches on page 3 7.
2.2. Pull on the finger access
tab to remove the cover
to access the top tether
anchor.