Yamaha TDM850'99 4TX-AE3 Service Manual page 15

Battery negative lead
1
Battery positive lead
2
Starter motor lead
3
Fuel sender lead
4
Fuel tank drain hose
5
Fuel tank breather hose (for DEU)
6
Water hose
7
Spark plug lead
8
Clutch cable
9
Brake hose
10
Throttle cable
11
Right handlebar switch lead
12
Headlight lead
13
Meter light lead
14
Speed sensor lead
15
Carburetor heater hose
16
CABLE ROUTING
Vacuum hose (#1)
17
Vacuum hose (#2)
18
Coolant reservoir breather hose
19
Carburetor breather hose
20
Rear brake switch lead
21
CYCLELOCK lead
22
A Route the battery positive lead
and battery negative lead through
the clamp.
B Fasten the wireharness Coolant
breather hose and flasher relay
lead.
C Route the carburetor breather
hoses through the engine clamp.
–9–
SPEC
D Fasten the carburetor air vent hose.
E Route the carburetor breather
hoses, vacuum hose (#1) down
ward and vacuum hose (#2) up-
ward through the guide.
F Route the vacuum hose (#1) inside,
vacuum hose (#2) outside through
the guide.
G Fasten the coolant reservoir hose.
H Fasten the wireharness right han-
dlebar switch lead meter lead and
headlight lead with a clamp.
I Route the relay lead through the
outside of wireharness.