Range And Oven - Winnebago 2003 adventurer Owner's Manual

SECTION 8
APPLIANCES & INTERIOR FEATURES
Refrigerator Access Compartment
To Open:
1. Use a coin to turn the latch knobs to the ver-
tical position as shown.
2. Remove the door from the opening.
Refrigerator Access Door Latches
To Close:
1. Replace the door into the opening.
2. Push the latch knobs in while turning to the
horizontal position as shown.

RANGE AND OVEN

The range and oven in your motor home are
operated on LP gas and will provide nearly all of
the functions that the range in your home does.
One benefit of gas burners is that heat is available
as soon as a burner is lit, as opposed to an electric
element slowly heating up. The range has a "Pilot
Off" position on the oven control which allows
the oven pilot to be turned off when traveling or
refilling the LP tank.
The following warning label has been located
in the cooking area to remind you to provide an
adequate supply of fresh air for combustion.
8-6
WARNING
IT IS NOT SAFE TO USE
COOKING APPLIANCES
FOR COMFORT HEATING
Cooking appliances need fresh air for safe
operation. Before operation
1. Open overhead vent or turn on exhaust fan.
2. Open window
FAILURE TO COMPLY COULD RESULT IN
DEATH OR SERIOUS INJURY.
Unlike large homes, the oxygen supply inside
a recreational vehicle is limited due to its size. To
avoid danger of asphyxiation, provide proper
ventilation when using the gas rangetop or gas
oven. It is especially important not to use the gas
oven and range top for comfort heating. Danger
of asphyxiation is greater when these appliances
are used for long periods of time without ade-
quate ventilation.
WARNING
Portable fuel-burning equipment
including wood and charcoal grills
and stoves, should not be used inside
the recreational vehicle. The use of
this equipment inside the recreational
vehicle may cause fires or asphyxia-
tion.
Using Range Top Burners
1. Rotate Top Burner Ignitor knob clockwise
(in the direction of the white arrows) to pro-
vide ignition spark.
2. While rotating the Ignitor knob, turn the
desired Burner Knob to the LITE position.
3. When the burner lights, release the Ignitor
knob and turn the Burner knob to the desired
flame height.