Table of Contents
Advertisement
cal substances but exposure to some harsh chem-
icals and solvents such as these can cause
damage that would need professional repair or
replacement. If one of these materials does spill
or drip onto the counter surface, wipe it up
immediately to avoid damage.
Technical Assistance. If you need assistance or
advice on care and maintenance of your solid
surface countertops, contact the countertop man-
ufacturer. Vendura Industries, Phone 608-223-
9555.
STAINLESS STEEL SINK
The stainless steel sink can be cleaned with
soap or detergent. Rinse thoroughly with warm
water and wipe dry to avoid streaks.
Use a mild abrasive for stubborn stains. Work
in the direction of the polish lines. To keep the
original finish, polish with a wax cleaner and rub
with a dry soft cloth.
WARNING
Salts, mustard and mayonnaise may
causing pitting. If spilled, clean
immediately.
BATHROOM
The tub and shower walls in the bathroom
should be cleaned with a mild soap and water
solution, or (to obtain maximum luster) use a
good quality wax cleaner. Do not use an abrasive
cleaner on the shower walls and tub. If the
shower has a glass door, it is extremely important
that abrasives not be used. Use only a good
quality glass cleaner or mild detergent and water
solution with a soft cloth to clean glass surfaces.
The bathroom lavatory is also a molded plas-
tic material and should be cleaned with a mild
soap and water solution. Abrasive cleaners or
harsh detergents should not be used.
For instructions on the care of your fresh
water toilet, refer to the information in your
Owner InfoCase.
CARE & MAINTENANCE
DOORS AND WINDOWS
Windows may be periodically cleaned with a
good quality glass cleaner or mild soap solution
using a soft cloth. Use care when removing ice or
frost from the windows. Always use a plastic ice
scraper, never one made of metal. Use care when
removing ice from the mirrors to protect the re-
flective surfaces.
Door locks and hinges should be lubricated
periodically with powdered graphite to ensure
trouble-free operation and to protect against
freeze-up.
VEHICLE MAINTENANCE
(See also Safety Precautions, Section 1 of this
manual).
CHASSIS SERVICE &
MAINTENANCE
Consult the appropriate sections in your chas-
sis operating guide for specific information re-
garding operating safety, service
recommendations and maintenance schedules for
the chassis section of your motor home.
Oil Change Reminder - Workhorse Chassis
The engine controller monitors the engine oil
life remaining and will display the message
"Change Engine Oil" on the Odometer/Message
Center display when an oil change is due. This
'counter' must be reset at the time the oil change
service is performed to be able to alert you for
the next change.
To Reset Oil Change Reminder:
•
Turn the ignition switch to "ON" but Do Not
Start the engine.
•
Fully press-and-release the accelerator pedal
3 times within 5 seconds, then turn ignition
"OFF" for at least 10 seconds.
SECTION 9
9-7
Advertisement
Table of Contents
