Table of Contents
Advertisement
Always leave this switch ON except during
storage periods (a month or more).
Aux. Batt. Disconnect Switch
in Entrance Stepwell
Pull-Out Passenger Work Station - Optional
Pull the worktop toward you until it clicks into
the fully extended position.
To Close: Lift the latch tabs and push the
worktop forward completely until it locks in
place on the dashtop.
WARNING
Do not use the passenger side front
workstation in the extended position
while the vehicle is in motion.
DRIVING YOUR MOTOR HOME
CB RADIO WIRING
Your coach is pre-wired for CB radio installa-
tion, the wires are located in the main wiring har-
ness beneath the instrument pod. Lift the
instrument pod as shown to access the wiring har-
ness.
CB Radio Wiring
Look for a pair of wires, yellow (+) and white
(-), with connectors and flag labels, suspended
from the wiring harness.
Be sure to read the wire labels before install-
ing a CB radio. The labels contain important in-
formation and cautions.
TO
CB RADIO
CB POWER PROVISION
CB POWER PROVISION
Yellow
RED
White
BLACK
Coax
COAX
(See Reverse Also)
(SEE REVERSE ALSO)
CB ANTENNA
CABLE
CB Radio Wiring
SWR ADJUSTMENT
To adjust CB antenna SWR (standing wave
ratio), remove the cap on the end of the antenna.
Turn the tuning ring on the antenna to achieve
SECTION 2
TO
CB RADIO WIRING
LABEL
+12 V
+ 12 V
Ground
GROUND
Antenna
ANTENNA
WIRE ASM-IP,MAIN
2-15
Advertisement
Table of Contents
