Trouble Shooting; Safety Rules - Gaggia Platinum swing up Operation And Maintenance Manual

Problems
The machine does not froth milk.
Please contact Gaggia customer service for problems not covered in the above trouble shooting section or when
a problem cannot be resolved.

SAFETY RULES

Never place live parts in contact with water: danger of short circuit! Steam and hot water can cause scalding!
I
NTENDED USE
The Milk Island is exclusively intended for domestic use.
The Milk Island cannot be used alone but must be connected to a preset coffee machine.
Do not make any technical changes or use the machine for unlawful purposes since this would create serious hazards!
The Milk Island and the coffee machine must only be operated by adults.
P
OWER SUPPLY
The Milk Island is powered by low voltage from the coffee machine to which it is connected by a special electro-
hydraulic connector.
P (
OWER CONNECTOR ELECTRO
Never use the Milk Island if the electro-hydraulic power connector is faulty.
If damaged, the electro-hydraulic connector must be replaced by the manufacturer or its customer service department.
The connector must not come into contact with liquids, wet parts or other substances that could alter the effectiveness
of the electrical contacts or cause a short circuit.
P
ROTECTING OTHERS
Be sure that no children operate the Milk Island.
Children are not aware of the risks linked with electrical appliances.
Do not leave the Milk Island packaging within the reach of children.
D
ANGER OF BURNING
Never direct the jet of hot steam and/or hot water towards yourself or others.
Always use the appropriate handgrip on the jug.
L
OCATION
Place the Milk Island and the coffee machine in a safe place, where it cannot overturned or cause injury.
TROUBLE SHOOTING - SAFETY RULES
Causes
The valve located in the cover is dirty.
The LED in the base of Milk Island is red.
Cover components not installed correctly.
The coffee machine is not ready to
dispense steam.
- )
HYDRAULIC
Solutions
Wash the valve.
Firmly push down on the milk jug.
Check cover assembly.
Check machine operation.
19