Installer Programming Menu - Philips SM40 Instructions For Use Manual

4. OPERATING AND PROGRAMMING THE SM40 SYSTEM
4.3.4

Installer Programming Menu

The Installer Programming Menu allows the user to program the following options:
Store System Hardware
Show System Hardware
- Call Stations connected
- Alarm Stations connected
- Key Stations connected
- Selection Stations connected
- PC inputs assigned
Routing Signal Generator
- Routing Signal Generator
- Routing to Matrix input
Manual Signal Selection
(for monitoring signals)
- Generator No..
- Signal No..
Route Message Source
- Message source
- Message card
Set Matrix Configuration
- Disable/Enable
- Time between last key-stroke
Setup I/O Parameters
Configure Call Stations
- Configure Extended CST
- Configure master CST
Route Digital Message Card
Message (Re-)Recording
Message Monitoring
Message Card Back-Up
Exit Programming Mode
Clear All Memory
Select Program
Shut-Off timer
Key: '4'
Key: '5'
- Input card(s)
- Matrix card(s) 16 inputs
- Matrix card(s) 32 inputs
- Signal generator(s)
- Message switch card(s)
Key: '6'
Key: '7'
Key: '8'
Key: '9'
Key: '0'
Key: 'A'
Key: 'B'
Key: 'C'
- Separate / combine
- Couple / Uncouple
Key: ' '
Key: ' '
Key: '
Key: ' '
Key: 'Break'
- Digital Message card(s)
- Locked CRC(s)
- Unlocked CRC(s)
- Serial I/O
- Communication PCB
4-19
4