Extension Frame - Ef - Philips SM40 Instructions For Use Manual

3. SM 40 BASIC SYSTEM AND EXTENSION FRAME
3.2

Extension Frame - EF

Single 19 inch rack frame, capable of holding 10 SM40 circuit cards. Complete with power supply,
Interconnection and Termination Boards.
A single rack frame, capable of holding, and interconnecting 10 SM40 circuit cards, has enough room to
accommodate the Basic (starter) System, described elsewhere, plus 1x Input Card, 3x Matrix Cards, and
1x Control Relay Card.
When the quantity of cards required in an SM40 system exceeds the amount of space offered in this single
rack frame, Extension Frame LBB 1360, is available.
Each Extension frame allows expansion of the system by up to 10 circuit cards, so that a system should be
specified as 1x Basic System LBB 1350; plus the extra circuit cards required; plus the quantity of extension
frames needed to accommodate those cards.
Units included with Extension Frame LBB 1360:
1x
1x
1x IB
1x TB
These components, mounted in the 19 inch rack frame, are supplied tested, and wired to accept and power
up to 10 SM40 circuit cards.
Note: All circuit cards controlled by the CPC must be mounted in the basic system and the first 7 extension
frames. All other cards (TCC, SPC, AVC, etc.) may then be mounted in as many frames as are necessary.
A maximum of 40 cards can be connected to one I
Single 19" rack frame
Power Supply Unit +15V/ -15V
Interconnection Boards
Termination Boards LBB 1377/00
2
C bus. The basic frame includes two I
LBB 1360/30
3
2
C busses.
3-3