Table of Contents
Advertisement
4. OPERATING AND PROGRAMMING THE SM40 SYSTEM
4.3
SM40 Programming
Status / Action
When memory was cleared the display shows:
When the system was installed previously,
the display shows:
4.3.1
User Programming Menu
4
Status / Action
To enter the User Programming Menu, enter
the password: '9', '6', 'Enter'.
Wait until the welcome message clears.
Press 'Break' to return the system to its
'Normal Run Mode'. Otherwise, to proceed
with the first programming option, press the
key marked '1', as shown in the display.
4-4
During the remainder of this chapter, specific contexts (status) and user actions are shown in the left
column, and possible display results are shown in the right column. Characters between quotes ('Key')
denote keyboard inputs, and ocurrances of
information which is dependant on the system configuration, or entered by the user.
When the SM40 system is powered up, either one of the following two displays is shown:
Result / Remarks
DAY XX-XX
The User Programming Menu allows the user to program the following options:
Call Station Programming
- Call Station No.
- Alarm Station No.
- User Key No.
- Key priority level
- Signal No.
- Digitally Stored Messages
- Unlocked CRC Relay
activation
- Routing to Amplifiers
Result / Remarks
Display after entering the password. Indicated here are the software version number
and release date.
* USER MENU *
PRESS '1' TO PROGRAM CALL STATIONS
The display now shows the first programming option.
Note: To scroll through the programming options, use the 'Enter' key.
XX
and
YY
in any displays shown in the right column denote
* * * SYSTEM MUST BE PROGRAMMED * * *
* * *
GO TO INSTALLER MENU
* * * SM40 ROUTING SYSTEM * * *
Auxiliary Programming
(for signals from a music source):
- Routing signals to 1 or more
outputs
>> WELCOME TO SM40 PROGRAMMING MODE <<
>> VERSION X.X
* * *
TIME XX:XX
Real-time clock / timer
settings
- Set real-time clock
- Program timers
DATE XX-XX-XX <<
scroll with 'ENTER'
Hide quick links:
Advertisement
Table of Contents
