Troubleshooting - JVC KW-AVX810 Instructions Manual

Troubleshooting

What appears to be trouble is not always serious. Check the following points before calling a service center.
• For operations with the external components, refer also to the instructions supplied with the adapters used for the
connections (as well as the instructions supplied with the external components).
Symptoms
• No sound comes out of the speakers.
• The screen is not clear and legible.
• "Position Error Push Open Key" appears on
the screen.
• "Mecha Error Push Reset" appears on the
screen, and the panel does not move.
• "SD Loading Error" appears on the monitor.
• "No Signal" appears.
• The buttons on the monitor panel do not
work.
• The unit does not work at all.
• The touch panel does not respond properly.
• <Illumination> function does not work
properly.
• SSM automatic presetting does not work.
• Static noise while listening to the radio.
Remedies/Causes
• Adjust the volume to the optimum level.
• Check the cords and connections.
• DTS sound cannot be reproduced through the analog
terminals (Speaker out/LINE OUT).
Sunshine from the windshield may cause this symptom.
Adjust <Bright>. (☞ page 58)
The monitor panel angle has been forcibly adjusted, or its
adjustment has been interrupted while opening or closing.
Press OPEN/TILT.
Reset the unit. (☞ page 3)
SD is not inserted fully. Fully insert it into the slot to close
the monitor panel.
• Change the source.
• Start the playback on the external component connected
to VIDEO IN plug.
• Check the cords and connections.
• Signal input is too weak.
When the monitor panel is open, only VOL +/– and OPEN/
TILT work. The other buttons do not function.
Reset the unit. (☞ page 3)
• Keep your hands and the touch panel clean and dry.
• Eliminate static electricity and do not place magnetic
items near the unit.
• Leave the unit until the temperature becomes stable in
the car.
• A rubber mat on the floor may cause this symptom. In
this case, do not use the rubber mat.
Store stations manually. (☞ page 15)
Connect the antenna firmly.
75
REFERENCES