JVC KW-AVX810 Instructions Manual page 77

Symptoms
• Noise is generated.
• Tracks cannot play back as you have intended
them to play.
• "Now Reading..." keeps flashing on the
screen.
• Correct characters are not displayed (e.g.
album name).
• While playing a track, sound is sometimes
interrupted.
• Bluetooth device does not detect the unit.
• The unit does not detect the Bluetooth
device.
• The unit does not make pairing with the
Bluetooth device.
• Echo or noise occurs.
• Phone sound quality is poor.
• The sound is interrupted or skipped while
using a Bluetooth audio player.
• "NEW DEVICE" cannot be selected for
"Bluetooth AUDIO."
• The connected audio player cannot be
controlled.
• "Reset08" appears on the screen.
Remedies/Causes
The track played back is not a playable file format. Skip to
another file.
Playback order may differ from the one played back using
other players.
• Readout time varies depending on the SD card/USB
device.
• Do not use too many hierarchy and folders.
• Turn off the power then on again.
For available characters. (☞ page 74)
The tracks are not properly copied into the SD card/USB
device. Copy tracks again, and try again.
This unit can be connected with one Bluetooth cellular
phone and one Bluetooth audio player at a time.
While connected to a device, this unit cannot be detected
from another device. Disconnect currently connected device
and search again.
• Check the Bluetooth setting of the device.
• Search from the Bluetooth device.
• Enter the same PIN code for both the unit and target
device. If the PIN code of the device is not indicated on its
instructions, try "0000" or "1234."
• Select the device name from <Special Device>, then
try to connect again. (☞ pages 35, 65)
Adjust the microphone unit position.
• Reduce the distance between the unit and the Bluetooth
cellular phone.
• Move the car to place where you can get a better signal
reception.
• Reduce the distance between the unit and the Bluetooth
audio player.
• Disconnect the device connected for "Bluetooth PHONE."
• Turn off, then turn on the unit.
• (When the sound is not yet restored,) connect the player
again.
Bluetooth audio player is already connected. To select
"NEW DEVICE," disconnect it. (☞ page 35)
Check whether the connected audio player supports AVRCP
(Audio Video Remote Control Profile).
Check the connection between the adapter and this unit.
77
REFERENCES