Preset Tuning - Technics SA-DX1050 Operating Instructions Manual

MEMORY
A
C
1 3 2 4
A
MEMORY
B
D
2 1
≥10/ENTER, 1–0
CH
1
PRESET
2
TUNING
M
M
TV VCR DVD
AUDIO TUNER/BAND TAPE CD
DIRECT TUNING/
1 2 3
DISC ENTER
6 ≥10/ENTER
4 5
7 8 9 0
TOP MENU MENU
ENTER
DISPLAY SUBWOOFER
/ /
– +
DELAY LEVEL
DISC/
DECK 1/2 SOUND MODE SFC TEST
TV/VIDEO CH MUTING
– +
VOLUME
The radio

Preset tuning

Choose either automatic presetting, which presets the stations the
tuner can receive, or manual presetting, which allows you to select
the stations to preset and the order in which they are to be preset.
There are 30 channels available for presetting.
Remember
If a new station is preset into a channel, the old station is erased.
A
Automatic presetting
Presetting FM stations
Preparation: Tune to the FM frequency where you want to begin
presetting ( \ page 22).
Press and hold [MEMORY].
The FM stations the unit can receive are preset in channels 1 to 30.
Presetting AM stations
Preparation: Tune to the AM frequency where you want presetting
to begin ( \ page 22).
Press and hold [MEMORY].
The AM stations the unit can receive are preset in channels 21 to
30. (FM stations are replaced if any were preset in these channels.)
During automatic presetting, the memory indicator flashes and the
frequency scrolls. The memory indicator and channel numbers are
displayed for a second when a station is preset (ı).
The last station to be preset is displayed when presetting finishes.
For your reference
Even if the power supply cord is disconnected from the household
AC outlet, the stations remain in memory for approximately one
month.
C Manual presetting
Preset the stations one at a time.
1 1 Tune to the station.
2 2 Press [MEMORY].
3 3 Press [TUNING 2 2 or 1 1 ] to select a channel.
4 4 Press [MEMORY].
D Selecting channels
1
Press [PRESET].
The channel number flashes for about 5 seconds.
2
Press [TUNING 2 2 or 1 1 ].
Hold down the buttons to change channels faster.
On the remote control
Press [CH 2 or 1].
or
Press the numbered buttons.
For channels 1 to 9, press the corresponding number.
For channels 10 or over, press [≥10/ENTER], then the two digits.
e.g. To select channel 21 [≥10/ENTER] / [2] / [1]
MHz
23
RQT5730