Preset Tuning - Technics SA-DA20 Operating Instructions Manual

MEMORY, PTY SEARCH
A
C
1 3 2 4
A
MEMORY
PTY SEARCH
B
D
2 1
STOP PAUSE
CHANNEL VOLUME
SOUND MODE
HELP
DIRECT TUNING/ TV VOL
DISC
1 2 3
4 5 6
7 8 9
DISC ENTER/
≥10/-/--
0
DECK 1/2
PLAY MODE SETUP CANCEL
SUB TITLE AUDIO ANGLE
REPEAT A-B
GROUP
1
PRESET
DISPLAY MODE
2
TUNING
PTY SELECTOR
PLAY
MUTING
CHANNEL, ,
SUBWOOFER
TV/AV
DVD 6CH
≥10/-/--, 1–0
DIGITAL
SFC
DELAY
LEVEL
The radio

Preset tuning

Choose either automatic presetting, which presets the stations the
tuner can receive, or manual presetting, which allows you to select
the stations to preset and the order in which they are to be preset.
There are 30 channels available for presetting.
Remember
If a new station is preset into a channel, the old station is erased.
A
Automatic presetting
Presetting FM stations
Preparation: Tune to the FM frequency where you want to begin
presetting ( \ page 22).
M
Press and hold [MEMORY, PTY SEARCH].
The FM stations the unit can receive are preset in channels 1 to 30.
Presetting AM stations
Preparation: Tune to the AM frequency where you want presetting
M
to begin ( \ page 22).
Press and hold [MEMORY, PTY SEARCH].
The AM stations the unit can receive are preset in channels 21 to
30. (FM stations are replaced if any were preset in these channels.)
During automatic presetting, the memory indicator flashes and the
frequency scrolls. The memory indicator and channel numbers are
displayed for a second when a station is preset (ı).
The last station to be preset is displayed when presetting finishes.
For your reference
Even if the AC mains lead is disconnected from the household
mains socket, the stations remain in memory for approximately one
month.
C Manual presetting
Preset the stations one at a time.
1 1 Tune to the station.
2 2 Press [MEMORY, PTY SEARCH].
3 3 Press [TUNING, 2, 1, PTY SELECTOR] to
select a channel.
4 4 Press [MEMORY, PTY SEARCH].
Selecting channels
D
1
Press [PRESET, DISPLAY MODE].
The channel number flashes for about 5 seconds.
2
Press [TUNING, 2, 1, PTY
SELECTOR].
Hold down the buttons to change channels faster.
On the remote control
Press [CHANNEL 1 or 2 ].
Or
Press the numbered buttons.
For channels 1 to 9, press the corresponding number.
For channels 10 or over, press [≥10/-/--], then the two digits.
e.g. To select channel 21: [≥10/-/--] / [2] / [1]
MHz
23
RQT5861