IP Menus
MAC Address Menu
Read-only
IP Address Menu
DSR-4550
Use the IP menus is to configure the 10/100 port. To access the IP menus, press
ENTER button to return to the main top-level menu (shown below).
E
Install Channel IP Status Diag
Press the 4 buttons until the cursor is at the IP label, and press the ENTER button.
The DSR-4550 displays the first sub-menu within the IP menus.
To view the MAC address for the lower Ethernet port on the back panel of the
DSR-4550, press the buttons until the MAC Address menu appears (shown
below). The address is represented in a hexadecimal format and non-editable.
PORT 10/100
E
Use the following procedure to set and view the IP address (range:
000.000.000.000 to 255.255.255.255) for the lower Ethernet port on the back panel
of the DSR-4550. The address is represented in the common dotted-decimal
format. Contact the network administrator for details about configuring the
Ethernet port for operation on your local network.
Press the buttons until the IP Address menu appears (shown below).
PORT 10/100
E
Important: Do not configure the IP Address of the 10/100 and GigE to be on the
same subnet.
To change the IP address, press the 4 button until the cursor is at the Address label, and
press the ENTER button to move into the field. Use the 4 buttons to select the digit
to change and then, while the cursor is on that digit, press the buttons to display
the desired value. Repeat this process for each applicable digit to be changed.
Press the ENTER button to confirm the selection and exit the field.
DSR-4550
MAC Address
hh-hh-hh-hh-hh-hh
IP Address
192.168.000.100
Operating the DSR-4550
45