Supervisor Password; Power Management; Screen Blank Mode (For The Windows 7 Operating System Only); Sleep Mode - Lenovo ThinkPad X240 Hardware Maintenance Manual

4. When the supervisor password icon is displayed, enter the supervisor password to enter the ThinkPad
Setup program.
5. Select Security.
6. Select Password.
7. Select Hard-disk x password, where x is the letter of the hard disk drive. A pop-up window opens.
8. Select Master hard disk password.
9. Type the current master hard disk password in the Enter Current Password field. Then leave the Enter
New Password field blank, and press Enter twice.
10. Press F10 to save changes and exit the ThinkPad Setup program. The user hard disk password and the
master hard disk password have been removed.

Supervisor password

A supervisor password protects the system information stored in the ThinkPad Setup. The user must enter
the supervisor password in order to get access to the ThinkPad Setup and change the system configuration.
Attention: If the supervisor password has been forgotten and cannot be made available to the service
technician, there is no service procedure to reset the password. The system board must be replaced for
a scheduled fee.

Power management

To reduce power consumption, the computer has three power management modes: screen blank, sleep,
and hibernation.

Screen blank mode (for the Windows 7 operating system only)

If the time set on the "Turn off monitor" timer in the operating system expires, the LCD backlight turns off.
To put the computer into screen blank mode, do the following:
1. Right-click the battery gauge on the taskbar.
2. Select Power off display.
To end screen blank mode and resume normal operation, press any key.

Sleep mode

When the computer enters sleep mode, the following events occur in addition to what occurs in screen
blank mode:
• The LCD is powered off.
• The hard disk drive or solid-state drive is powered off.
• The microprocessor stops.
To enter sleep mode, do one of the following:
• For Windows 7: Click the arrow beside the Shutdown icon from the Start menu, and then select Sleep.
To return from sleep mode, press the Fn key.
• For Windows 8: Move the cursor to the bottom-right corner of the screen to display the charms. Then
click Settings ➙ Power ➙ Sleep.
In certain circumstances, the computer goes into sleep mode automatically:
• After a period of inactivity specified in power plan settings
34
Hardware Maintenance Manual