Asr&R Submenu - Fujitsu PRIMERGY RX600 S3 User Manual

Chapter 8 Configuring Hardware and Utilities
8.3.9 ASR&R Submenu
Settings for booting control are configured on the [ASR&R] submenu.
Item
O/S Boot Timeout
O/S Boot WD Time (min)
O/S Boot WD Behavior
ASR&R Boot Delay (min)
Power Cycle Delay
Boot Retry Counter
Diagnostic System
Next Boot Uses
Diagnostic Lan Device
Temperature Monitoring
254
table: Items on the ASR&R Submenu
Settings
• Enabled Set whether or not to enable the "OS Boot
• Disabled (initial value) Monitoring" function. The system restarts
automatically in case of stopping booting the OS.
This can be set on the ServerView.
Note:
• 100 (initial value) Set the time out value by the minute.
• 0 ～ 100
• Continue (initial value) Set the behavior in time out.
• Reset
• Power Cycle
• 2 (initial value) Set the standby time between shutdown and
restarting by the minute. When the standby time
• 0 ～ 30
passes, the system is restarted.
• 5 (initial value) Set the time between power off and on.
• 0 ～ 15
• 3 (initial value) Set a maximum number of retrying OS booting.
• 0 ～ 7
Disabled（unchangeable） This value cannot be changed.
Boot Option This value cannot be changed.
(unchangeable)
Use Boot Order This value cannot be changed.
(unchangeable)
Disabled (unchangeable) Set whether being possible to turn on the server
outside the range of temperature conditions (10 to 35
degrees C).
Description
Be sure to set "Disabled" when the
ServerView is not installed to the OS. If you
set "Enabled" in above case, unintended
power-off or restarting may occur.
Even with the ServerView, when the system is
booted with the ServerStart CD-ROM or DOS
floppy disk, be sure to set "Disabled". If you
set "Enabled" in above case, unintended
power-off or restarting may occur.
To set this function, refer to "ServerView
User's Guide" to understand the
specifications and operational procedures.