Install The Light(S) And Lens(Es); Attach Manual Release Rope And Handle - Chamberlain Series 1200 Owner's Manual

Installation Step 7
Install the Light and the Lens
Install the light:
• Install a 75 watt maximum light bulb in the socket.
The light will turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the light will turn OFF.
• If the bulbs burn out prematurely due to vibration,
replace with a standard-neck "Garage Door
Opener" bulb.
Install the lens:
(All Models except 1240R)
• Locate and loosen (approximately 1/8") the two
screws near top of opener front panel. Position
lens against panel with slotted tabs directly below
screws. Slide lens up to seat tabs behind screws.
Snap bottom tabs of lens into panel slots.
Retighten top panel screws to secure lens.
Installation Step 8
Attach the Manual Release
Rope and Handle
Trolley
Rope
Overhand
Knot
Do not use the red handle to pull the door
open or closed. The rope knot could become
untied and you could fall. Use the manual
release only to disengage the trolley and, if
possible, only when the door is closed.
Garage doors are heavy. If the door is open
when the handle is pulled, the door could
close inadvertently if it is not properly
balanced. Serious injury may result to persons
under the door. Make sure the doorway is clear
Overhand
of persons and obstructions before pulling
Knot
handle when door is open.
Trolley
Release Arm
• Thread one end of the rope through the hole in the
top of the red handle so "NOTICE" reads right side
up as shown. Secure with an overhand knot at least
Manual
1" from the end of the rope to prevent slipping.
Release Handle
• Thread the other end of the rope through the hole in
the release arm of the outer trolley.
• Adjust rope length so the handle is 6 feet above the
floor. Secure with an overhand knot.
If it is necessary to cut the rope, heat seal the cut end
with a match or lighter to prevent unraveling.
19
Light
Lens
75 Watt Max.
Light Bulb
Lens Tab
WARNING
Panel Screw
Lens Slot