Maintenance - Stanley HGE12 User Manual

MAINTENANCE

WARNING: To reduce the risk of serious per-
sonal injury, turn tool off and disconnect battery pack
before making any adjustments or removing/install-
ing attachments or accessories.
Cleaning
WARNING: Blow dirt and dust out of all air
vents with clean, dry air at least once a week. To
minimize the risk of eye injury, always wear ANSI
Z87.1 approved eye protection when performing this.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the char-
ger from the AC outlet before cleaning.
Dirt and grease may be removed from the exterior of
the charger using a cloth or soft non-metallic brush.
Do not use water or any cleaning solutions.
Accessories
WARNING: Since accessories, other than
those offered by DEWALT, have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
Stanley Hydraulic Tools, recommended accessories
should be used with this product.
If you need any assistance in locating any accessory,
please contact Stanley Hydraulic Tools at 3810 SE
Naef Rd, Milwaukie, OR 97267, (503-659-5660) and
ask for a customer service representative also visit
our website www.stanleyhydraulic.com.
Repairs
The charger is not serviceable. There are no ser-
viceable parts inside the charger. To assure product
SAFETY and RELIABILITY, repairs, maintenance
and adjustments (including brush inspection and
replacement) should be performed by a DEWALT
factory service center, a DEWALT authorized service
center or other qualified service personnel. Always
use identical replacement parts.
12 ► HGE12 User Manual
MAINTENANCE
TROUBLESHOOTING
Tool will not run:
• Battery pack not charged.
• Battery pack not inserted properly.
Grinder operates too slow:
• Low battery charge
• Too much down pressure.
Short battery life:
• New batteries or batteries that have been
• Charge battery pack
• Make sure battery pack is fully
inserted & clicks firmly into place.
• Charge battery per instructions.
• Do not use excessive down pressure
while grinding.
stored for some time, may not initially
accept a full charge.
• This is normal, it will charge fully
after several charge and discharge
cycles. Also see charging procedure
in this manual.