Controller Status Indicators; Hsv300 Controller Port Status Indicators; Hsv300-S Controller Port Status Indicators - HP StorageWorks 4400 User Manual

Figure 12 shows the back view of the HSV300–S controller enclosure
Management module
The web-based operator control panel (WOCP) provides a direct interface to the management module
within each controller. From the WOCP you can display storage system status and configuration
information, shut down the storage system, and manage the password. For tasks to perform with the
WOCP, see the WOCP online help.
The WOCP provides two levels of administrator access and an interface for firmware updates to the
management module. For additional details about the WOCP, see the WOCP online help.

Controller status indicators

The status indicators display the operational status of the controller. The function of each indicator is
described in Table
Each port on the rear of the controller has an associated status indicator located directly above it.
Table 5 lists the port and its status description for the HSV300.
descriptions for the HSV300–S.
Table 5 HSV300 controller port status indicators
Fibre Channel host ports
Fibre Channel device ports
1
On copper Fibre Channel cables, the SFP is integrated into the cable connector.
Table 6 HSV300-S controller port status indicators
Fibre Channel switch ports
Fibre Channel device ports
24 EVA4400 hardware
7. During initial setup, the status indicators might not be fully operational.
Port
• Green — Normal operation
• Amber — No signal detected
•
Off — No SFP
• Green — Normal operation
• Amber — No signal detected or the controller has failed the port
•
Off — No SFP
Port
• Green on — Normal operation or loopback port
• Green flashing — Normal online I/O activity
• Amber on — Faulted port, disabled due to diagnostics or Portdisable
command
• Amber flashing — Port with no synchronization, receiving light but not
yet online or segmented port
•
Off — No SFP
• Green — Normal operation
• Amber — No signal detected or the controller has failed the port
•
Off — No SFP
Table 6 lists the port and its status
Description
1
detected or the Direct Connect WOCP setting is incorrect
1
detected
Description
1
, no cable, no license detected.
1
detected