Tuning In To A Preset Station - JVC KD-G700 Instructions Manual

Manual preset
You can preset up to 6 stations in each band
(FM1, FM2, FM3, and AM) manually.
Ex.: Storing FM station of 92.5 MHz into the
preset number 1 of the FM1 band.
1
Select the band (FM1 – 3, AM) you
want to store stations into (in this
example, FM1).
FM 1
(F1)
2
Tune in to a station (in this example,
of 92.5 MHz).
To tune in to stations of lower frequencies
3
Press and hold the number button
(in this example, 1) for more than
2 seconds.
Preset number flashes for a while
12
Each time you press the
button, the band changes as
follows:
FM 2 FM 3 A M
(F2) (F3) (A1)
To tune in to stations of
higher frequencies
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new
station is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example,
during battery replacement). If this occurs, preset
the stations again.

Tuning in to a preset station

You can easily tune in to a preset station.
Remember that you must store stations first. If
you have not stored them yet, see "Storing
stations in memory" on pages 11 and 12.
1
Select the band (FM1 – 3, AM).
Each time you press the
button, the band changes as
follows:
FM 1 FM 2
(F1) (F2)
2
Select the number (1 – 6) for the
preset station you want.
Note:
You can also use the (up) or
the unit to select the next or previous preset stations.
Each time you press the
the next or previous preset station is tuned in.
FM 3 A M
(F3) (A1)
(down) button on
(up) or (down) button,