Maytag REFRIGERATOR Installation Instructions Manual page 12

Co 0 +r++r /l'l,dl
240Edwards S treet. S E
C;aveiand, Tennessee 37311
Tei:423-472-3333
Fax: - 123-478-6710
6. Open the refrigerator door slightly, and tilt the top to clear the center hinge. Lift the door
off the lower hinge pin and place it aside for now.
7. Remove the center hinge by removing two (2) screws using a 5/16" socket wrench.
8. Remove screws from opposite side of the cabinet, using a Torx-T25 drive.
=::
o o
S
9. Turn the center hinge over and reinstall on the left side of cabinet using the same screws
you just removed from the center hinge. Reinstall the screws that were used on the opposite
side. NOTE: If door removal is necessary on those models with an ice and water fountain,
use care in removing the water and electrical lines from the hinge by pulling the water line
first followed by the electrical wires.
REVERSING FREEZER DOOR
t0. Take the freezer door and remove screw from the trim cap on the top of the door.
11. Remove the screw holding metal handle bracket at the top of the door.
t2. Remove two (2) screws holding handle to bottom of door. Handle and trim should be
completely removed from freezer door.
13. With a putty knife, pry off the plugs on the left side of the top of the door. Take care
not to damage them or the door.
14. Put the plugs into exposed holes on the right hand side of the freezer door. These would
be the holes from which the screws were removed.