Table of Contents
Advertisement
Quick Links
,.STA'LAT,O--
Remove
and discard
cantilexer
shelf packing clips
_"
located just above each shelf where it hooks onto the
frame. To remove plastic dips, wiggle the clips sideways
and
pull straight out.
_"
Locating
Your Refrigerator
tuRN LEG C LOCKWISE
TO
RAISE
CABINET
CORNER.
1. Allow a free flow of air through the t?ont base grille.
TURN LEG
COUNTER-
CLOCKWISE
TO LOWER
2. Your model should not be installed where tim room
CABINET CORNER.
temperature
will go below 55 degrees F., because it
will not run frequently enough to maintain proper
_'_
temperature
in the f?ceezer.
3. For ease of installation, you should leave a space of
If the floor is not level and it is necessary to raise the
about 1/2 inch bee,veen the refrigerator and adjacent
rear of the cabinet,
we suggest rolling the rear
walls or cabinets. If the refrigerator is placed with
wheels onto a piece of plywood
or other shim
the hinge side against a wail, you may want to leave
material.
additional space so the door can be opened x_dder.
4, To replace, center the clips in the cut-out areas and
(Refer to the installation
instructions
for more
push in until the base grille snaps into place.
detail.)
Connecting
the Appliance
Important
Leveling
Information
Your refi'igerator
is equipped
with front and back
WallNING:
This appliance is designe d to operate
on a nominal il.5 volt, 15 amp, 60 cyele line. There
rollers so it can be moved away from the wall for
cleaning. The front rollers are adjustable and should be
should be a separate, grounded
circuit
serMng this
v
positioned so the refrigerator
sits firmly on the floor
appliance only. Do not use an extension cord.
andis level.
This appliance
is equipped
with a three-prouged
I _
TO adjust
the
front
rollers:
grounding
ping for your protection
against possible
J _"
1. Remove the base grille by grasping the ends, lift and
electrical
shock hazards. It mnst be plugged
into a
_'I
pull out.
grounding
receptacle.
Where
a standard
two-prong
wall receptacle
is encountered,
it is the personal
responsibili_
and obligation of the customer to have it
replaced with a properly grounded
three-prong
wall
at_
receptacle.
Do not under any circumstances,
cut or
remove the third (ground) prong from tim power cord.
Do not use an adapter plug.
"2.To level the refrigerator, use a screwdriver and turn
_.
roller adjusting screws cloc_vise to raise the cabinet
or counterclockwise
to lower the cabinet.
. ,.
3, It is not necessary to lock the refrigerator in place.
However, if that is desirable, turn one or both of the
locking feet clockwise, Tbey are located near the
f?ont wheels.
PAGE 1
Advertisement
Table of Contents
