Accessories Supplied; General Information - Carrier 51AKP Owner's Manual

Accessories supplied

STAND-ALONE
1

General information

Unit installation
Read this instruction manual thoroughly
before installing the unit and keep it for
further consultation even after
installation.
• This unit complies with the following
directives:
- low-voltage 73/23/CEE;
- electromagnetic compatibility
89/336/CEE;
- PED Pressure Equipment 97/23/CE;
- energy labelling 2002/31/CE;
- RoHs directive compliance.
• For safety reasons, installers are required
to read the general information carefully.
• Follow all the instructions below to ensure
safety.
• Inspect the unit for damage due to
improper transport. In case of damage,
file an immediate claim with the shipping
company.
• Do not install or use damaged equipment.
• To prevent fire, explosion or injury, do not
operate the unit near dangerous substances
or close to naked light equipment.
• Ensure that national safety code
requirements have been followed for the
main supply circuit.
Follow all current national safety code
requirements for the installation.
• Make sure a connected ground wire is
in place.
• Check that voltage and frequency of the
mains power supply are those required for
the unit to be installed; the available
power must be adequate to operate any
other appliances connected to the same
line. Models 51AKP300E and
51AKP310M can be connected only to a
supply with system impedance no more
than 0.424ohm.
• The manufacturer declines any liability
from damage resulting from modifications
in the unit or errors in the electrical or
hydraulic connections. Failure to observe
the installation instructions, or use of the
unit under conditions other than those
indicated in the table "Operating limits" of
the unit owner's manual, will immediately
invalidate the unit warranty.
• It is recommended to install a circuit
breaker or a 10 A safety fuse for STAND-
ALONE units.
Unit operation
• This appliance has an automatic
function of 'unit restart' (in the last
GB - 2
2
mode selected) after an AC power
interruption.
• In order to avoid electric shock, fire or
injury, stop the unit in case of abnormal
events (such as smell of burning) and call
Carrier Service for further instructions.
• Do not place containers filled with liquids
or other objects onto the unit.
Maintenance
WARNING: disconnect the mains power
supply prior to any maintenance
operations or prior to handling any
internal parts of the unit.
• The appliance must be maintenanced
every one year.
• Use of accessories that are not expressly
recommended by the manufacturer can
result in injuries and harm.Therefore use
only original accessories.
• A routine maintenance should be carried
out on the unit to check the correct
operation of the electric connections and
protection devices.
• Maintenance operations must be carried
out by specially trained personnel.
• Do not attempt to repair, move, modify the
unit on your own.
To avoid electric shock or fire make sure
these operations are carried out by
qualified personnel only.
• Contact the qualified service if one of the
following events takes place:
- hot or damaged power supply cable;
- unusual noise during operation;
- frequent operation of the protection
devices;
- unusual smell (such as smell of
burning).
Choosing the installation site
• Choose an area free from obstructions
which may cause irregular air distribution
and/or return.
• Choose a position that allows for the
clearances required.
The distance between the return air grills
and any walls, furniture or obstructions of
all kinds must be at least 50 cm.
• Look for a position in the room which
assures the best possible air distribution.
• Only use the appliance inside and for its
designated purpose.
• The appliance shall be installed in
accordance with national wiring
regulations.
3
1. Air outlet vent
2. Flexible hose
3. Front and back
plastic pipe ends
4. Fastening strap
with suction cup
4
Positions to avoid:
• Exposed to direct sun.
• Too close to heat sources.
• On humid walls or positions with water
hazard, e.g. laundry premises.
• Exposure to oil vapours (e.g. kitchens,
workshops).
• Where curtains or furniture may obstruct
free air circulation.
• The appliance must not be installed in
laundry rooms.
• The appliance must be positioned so that
the plug is accessible.
Additional cares
• Keep out of reach of children.
• Do not obstruct the sides, front and rear
grille with curtains or other objects.
Do not put objects on the unit.
• Do not insert hands or anything else into
the air inlet or outlet,
• Keep the unit more than 1m far from TV to
avoid electromagnetic wave interference.
• Never incline or overturn the unit.
• Never spray insecticide or other gases to
avoid deformation of the unit.
• The appliance should always be moved or
transported in a vertical position.(Beware:
Plug out the power supply before moving)
Unit disposal:
• At the end of its life, the air conditioner
must be delivered to a special collection
centre or to the dealer for the refrigerant
disposal.
• All of the manufacturing and
packaging materials used for this unit
are compatible with the environment
and can be recycled.
• Dispose of the packaging material in
accordance with local requirements.
• DISPOSAL:Do not dispose this
product as unsorted municipal
waste. Collection of such waste
separately for special treatment
is necessary.
STAND-ALONE unit performance:
The unit is suitable for operation within the
following temperature limits according to
the standards:
Cooling: (EN14511:2004)
Max. 35°C d.b.* /24°C w.b.*
Min. 21°C d.b.* /15°C w.b.*
Dehumidification:
Max. 32°C d.b.* / 24°C w.b.*
Min. 18°C d.b.* / 14°C w.b.*
* d.b. - dry bulb temperature
* w.b. - wet bulb temperature