Specifications - Crown XLi 800 Operation Manual

XLi Series Power Amplifiers

Specifications

Guaranteed Minimum Power
1 kHz (EIA) with 0.5% THD
4  stereo (per channel)
8  stereo (per channel)
8  bridge mono
Performance
Frequency Response (at 1 Watt)
Total Harmonic Distortion (THD)
Intermodulation Distortion (IMD)
60 Hz and 7 kHz at 4:1, from full rated output
to –30 dB
Slew Rate
Voltage Gain
Damping Factor (8 ), 10 Hz - 400 Hz
Signal-to-Noise Ratio (below rated power,
20 Hz to 20 kHz, A-weighted)
Crosstalk (below rated power)
At 1 kHz
At 20 kHz
Input Sensitivity for full rated power at 8 
Input Impedance (nominal)
Balanced
Unbalanced
Connectors, Controls and Indicators
Input Connectors
Output Connectors (Speaker Connectors)
Front Panel Controls
Rear Panel Controls
Power Indicator
Signal Indicator
Clip (peak) Indicator
Fault Indicator
Construction
Protection
Ventilation
Cooling
Dimensions (W x H x D)
Net Weight
Shipping Weight
Operation Manual
XLi 800 XLi 1500
300W 450W
200W 330W
600W 900W
20Hz - 20kHz, +0/-1dB
< 0.5%, 20 Hz - 20 kHz
29dB 31dB
One balanced XLR and one unbalanced RCA per channel
4-POLE Speakon and one pair Binding Post per channel
®
Power on/off switch, one gain control per channel
Output mode switch: stereo (dual), parallel or bridge
Input sensitivity switch: 0.775V or 1.4V
One green LED per channel
One yellow LED per channel
One red LED per channel
Protection against short circuits, no-load, on/off muting,
RF interference. Stable into reactive or mismatched loads
Flow-through ventilation from front to back
Internal heat sinks with forced air. Fan cooled,
speed regulated, thermal protection
19" x 3.5" x 12.4"
(482 mm x 89 mm x 315 mm)
25.1 lb (11.4 kg) 28.0 lb (12.7 kg)
29.5 lb (13.4 kg) 32.4 lb (14.7 kg)
XLi 2500
750W
500W
1500W

0.35%
>10V/us
33dB
> 200
> 100 dB
–75 dB
–59 dB
0.775V or 1.4V
20 k
10 k
One blue LED
29.7 lb (13.5 kg)
34.2 lb (15.5 kg)
XLi 3500
1350W
1000W
2700W
36dB
19" x 3.5" x 14.4"
(482 x 89 x 366 mm)
43.0 lb (19.5 kg)
47.4 lb (21.5 kg)
page 9