Table of Contents
Advertisement
Available languages
Available languages
CONNECTIONS
Notes
For connection between the DAC-10 and digital equipment, use a 75-ohm coaxial cable or
optical fiber cable.
For analog input/output connections, use shielded audio cables and take care not to mix up
left and right channels.
Do not make connections to a component with balanced and unbalanced cables at the
same time. Otherwise ground loops may occur, which can cause noise.
Option board installation example shown in illustration
OPTION: Digital Input Board
output level
5
4
6
3
7
fm stereo tuner
2
8
model T-109V
1
9
0
10
STEREO
SELECTIVITY
NORMAL
SIGNAL
ANALOG OUT
DIGITAL OUT
STEREO
SELECTIVITY
NORMAL
This set relies on cooling with a natural flow of air between the ventilation
holes on the top and bottom. When installing the set, leave at least 10 cm of
space at both sides, the top and the back to allow for normal ventilation.
Do not place any object containing liquid (vases, flower pots, bottles with
cosmetics or chemicals, etc.) on top of the unit. If a spill occurs, there is a risk
of fire and electric shock.
If there is a problem with the unit or if malfunction occurs, always disconnect
the power cord from the AC outlet! This is absolutely essential, because simply
setting the power switch to OFF will not completely separate the unit from the
AC source.
mm
B
compacr disc player
ANALOG
OUTPUTS
MEMORY
MH
Z
CH
METER
MEMORY
MH
Z
CH
METER
SIGNAL
Before making connections, be sure to switch
the power to all components off.
DAC-10
DP-65V
STEREO
MEMORY
MH
Z
CH
SELECTIVITY
METER
NORMAL
SIGNAL
2
Advertisement
Table of Contents
