Table of Contents
Advertisement
Modem Activation
NOTE: CradlePoint IBR650E modems purchased from CSI will be pre-confi gured; however, if your modem has
lost its confi guration, you can load a confi guration fi le or manually set up your modem. The default confi gura-
tion fi le is included on the CD that shipped with your modem kit. Alternatively, you can request a confi gura-
tion fi le from productsupport@cellularspecialties.com
The default confi guration has the following parameters:
•
DHCP is off
•
Port forwarding is set up for http (port 80), SNMP (ports 161/162) & SSH (port 22) for 2 devices
•
Both Ethernet 0 & Ethernet 1 should be set to Local Network (LAN).
•
Routing mode is NAT and Access Control for both the Primary & Guest LAN is set to Admin Access
CradlePoint IBR650E Setup Instructions for Verizon Wireless DSP
Deployments
Step 1
Getting the modem ready for OTASP (Over the air service provisioning)
-
NOTES: Do not make any changes to the DSP Local Network, Remote Network or SNMP Confi gura-
tion in the DSP interface UNLESS the DSP has already been confi gured for use with a CSI Remote
Monitoring Kit using a USB connection. If this is the case, log into the DSP, click on the Remote
Network tab, choose "Disabled," click on "Change Settings" and then reboot the DSP prior to pro-
ceeding.
Manually set your computer's IP address to 192.168.1.2.
Connect a straight through ethernet patch cable from to your laptop ethernet port to the "COMPUTERS or
LOCAL DEVICES (LAN) default" port of the CradlePoint IBR650E.
work settings, please refer to the "Additional Tips" section of the DSP user's manual or to your OS documen-
tation.
Go to 192.168.1.1 in your browser to launch the setup GUI. You should see the following screen:
Enter the default password, which is csi1234.
If you need assistance changing your net-
-12-
Advertisement
Table of Contents
