Cradlepoint DSPMOD-CP-S Product Manual

External cdma modem kit

Advertisement

Quick Links

DSPMOD-CP-S/CDMA & DSPMOD-CP/CDMA
External CDMA Modem Kit

Advertisement

Table of Contents
loading

Summary of Contents for Cradlepoint DSPMOD-CP-S

  • Page 1 DSPMOD-CP-S/CDMA & DSPMOD-CP/CDMA External CDMA Modem Kit...
  • Page 2 This page intentionally left blank.
  • Page 3: Table Of Contents

    Step 1 Getting the modem ready for OTASP (Over the air service provisioning) ..12 Step 2: Activating the CradlePoint IBR650E on the Verizon Wireless Network: ..13 Step 3: Confi guring your modem for port forwarding ..........15 Port Forwarding ......................... 15 LAN Settings ........................
  • Page 4: Product Registration Information

    Product Registration Information If applicable the ESN number may be found on the label on the bottom of the router. Note ESN number below. If not yet activated, the ESN number will be required to do so. Retain this manual, along with proof of purchase, to serve as a permanent record of your purchase.
  • Page 5: Product Introduction

    (1) 820-2122-014 - 14’ Ethernet Cable Product Introduction This document describes the CradlePoint IBR650E Setup Instructions for Verizon Wireless DSP Deployments. Prior to Installation Verify all the required components from the lists above are on hand prior to starting the installation process.
  • Page 6: Cradlepoint Ibr650E Hardware Overview

    CradlePoint IBR650E Hardware Overview Ports, LED’s and Switches Power 12VDC: The power connector includes two pins for power and two pins for GPIO (General Purpose Input/Output) functionality. The included power adapter, however, only connects to the power pins. You will need a separate adapter for GPIO functionality.
  • Page 7 Power On/Off: - I = On - O = Off Power LED: - Blue = On - No light = Off ATTN LED: - Used with Modem LED for additional LED indications below. Modem LED: - Green = On and operating normally - Blinking Green = Connecting - Amber = Not available (idle, for example) - Blinking Amber = Cellular data connection error...
  • Page 8: Mounting Bracket

    Mounting Bracket...
  • Page 9: Attaching The Ibr650 To The Mounting Bracket

    Attaching the IBR650 to the Mounting Bracket 1) Attach the bracket to the wall or other surface with screws. NOTE: Screws are not provided because the type of screw required depends on the mounting surface 2) Place the router‘s edge against the bottom of the bracket.
  • Page 10: Removing The Ibr650 From The Mounting Bracket

    Removing the IBR650 from the Mounting Bracket From the top of the bracket, press down fi rmly on the router using your thumb(s) and pull the device out. Basic Setup 1. Attach one modem antenna to the RX Diversity Port. -10-...
  • Page 11 2. Plug the power supply into an electrical outlet and connect it to the IBR650. 3. Make sure the power is switched on. RX Diversity Port O = OFF I = ON -11-...
  • Page 12: Modem Activation

    Modem Activation NOTE: CradlePoint IBR650E modems purchased from CSI will be pre-confi gured; however, if your modem has lost its confi guration, you can load a confi guration fi le or manually set up your modem. The default confi gura- tion fi...
  • Page 13: Step 2: Activating The Cradlepoint Ibr650E On The Verizon Wireless Network

    Step 2: Activating the CradlePoint IBR650E on the Verizon Wireless Network: Click on the Internet tab, then select Connection Manager Next, highlight “Modem: Internal EVDO and then click on Control -13-...
  • Page 14 Click on the Activate button The modem will now contact the Verizon Wireless Network for authentication. If the ESN has been set up with an active account, the modem will respond activated within 3-5 minutes. Once you see the above message, reset or power cycle the modem using the on/off switch. -14-...
  • Page 15: Step 3: Confi Guring Your Modem For Port Forwarding

    CradlePoint IBR650E modems purchased from CSI will be pre-confi gured; however, if your modem has lost its confi guration, you can load a confi guration fi le or manually set up your modem. The default confi guration fi le is included on the CD that shipped with your modem kit.
  • Page 16: Lan Settings

    LAN Settings Under Network Settings, select Local Networks. On both Primary & Guest LAN, DHCP Server should be dis- abled to prevent misuse of the modem. You may change the Guest LAN IP Address at this point. The Guest LAN IP can be used to monitor other DAS equipment on a different network/subnet.
  • Page 17: Additional Features

    Additional Features System Automatic Reboot – The CradlePoint IBR650E allows you to set an automatic reboot daily, weekly or monthly. Go to System Settings, System Control to utilize this feature. -17-...
  • Page 18: Dual Lan

    Dual LAN The CradlePoint IBR650E allows the use of 2 distinct LAN’s, which is useful when connecting equipment that already has an established subnet (a fi ber DAS network for example). Either Ethernet port will support either LAN. The Guest LAN IP Address can be changed to support your requirement. Click on the checkbox next to Guest LAN, then click on Edit.
  • Page 19 Donor antenna, coax down lead and repeaters are sold separately. -19-...
  • Page 20 Donor antenna, coax down lead and repeaters are sold separately. -20-...
  • Page 21: Functionality Test

    3. Please remember to document the User Name and Password, and provide this to the Wireless Service Pro- vider representative who is monitoring the DSP. 4. Additional documentation can be found @: http://www.cradlepoint.com/products/machine-to-machine- routers/cor-ibr650-3g-router-no-wifi Additional Tips Instructions to change TCP/IP settings on your Windows computer.
  • Page 22 Right click on Local Area Connection - and select “Properties”. Scroll down and highlight “Internet Protocol (TCP/IP) and click on the “Properties” button. If you are set up to use DHCP, the window shown below will be displayed. -22-...
  • Page 23 Select “Use the following IP address:” and enter “192.168.1.2.” The subnet mask should automatically popu- late to “255.255.255.0. While most devices automatically detect DNS, you can set the DNS to the settings shown on the Dashboard screen of the modem user interface. Default Gateway of computer has to = the IPAddress of the modem Pref- fered DNS servers = modem DNS Servers #1 Alternate DNS server = modem DNS Servers #2.
  • Page 24 If this is the case simply plug in the laptop to a 110vac source or change the power set- tings to enable the Ethernet port when the laptop is using battery power. Index Modem Activation 12 Activating the CradlePoint IBR650E on the Verizon Modem Antennas 7 Wireless Network 13 Modem LED 7...
  • Page 25: Warranty

    Warranty This is a one year limited warranty. Seller warrants that its prod- ucts are transferred rightfully and with good title; that its prod- ucts are free from any lawful security interest or other lien or encumbrance unknown to Buyer; and that for a period of one year from the date of installation or fi...
  • Page 26 Notes -26-...
  • Page 27 Notes -27-...
  • Page 28 960-1147-003 rev A ECO 2707...

This manual is also suitable for:

Dspmod-cpDspmod-cp-s/cdmaDspmod-cp/cdma

Table of Contents