Adjusting The Sound - JVC GET0188-001A Instructions Manual

Adjusting the sound

You can adjust the sound characteristics to your
preference.
1
Select the item you want to adjust.
BAS
(bass)
VOL
(volume)
Indication To do:
1
BAS* Adjust the bass.
1
TRE* Adjust the treble.
FAD* 2 Adjust the front
and rear speaker
balance.
BAL Adjust the left
and right speaker
balance.
LOUD* 1 Boost low and high
frequencies to
produce a well-
balanced sound
at low volume level.
VOL* 3 Adjust the volume.
24
Each time you press the
button, the adjustable items
change as follows:
TRE FAD
(treble) (fader)
BAL
LOUD
(balance)
(loudness)
Range
–06 (min.)
|
+06 (max.)
–06 (min.)
|
+06 (max.)
R06 (Rear only)
|
F06 (Front only)
L06 (Left only)
|
R06 (Right only)
LOUD ON
|
LOUD OFF
00 (min.)
|
30 or 50 (max.)*
* 1 When you adjust the bass, treble, or loudness, the
adjustment you have made is stored for the currently
selected sound mode (C-EQ) including "USER."
* 2
If you are using a two-speaker system, set the fader
level to "00."
* 3
Normally the control dial works as the volume
control. So you do not have to select "VOL" to
adjust the volume level.
4
* Depending on the amplifier gain control. (See
page 28 for details.)
2
Adjust the setting.
Indication pattern changes as
you adjust the bass or treble.
Ex. 1: When you adjust "TRE" (treble)
Ex. 2: When you turn on the loudness
3
Repeat steps 1 and 2 to adjust the
other items.
To reset each sound mode to the factory
settings, repeat the same procedure and
4
reassign the preset values listed in the table on
page 23.
To increase the level or
turn on the loudness
To decrease the level or
turn off the loudness