Wolf 30" Installation Manual page 6

INSTALLATION
Installation
WALL HOOD
If an internal blower is being installed, install the blower prior
to mounting the hood. Refer to page 8 for internal blower
installation.
Mark the center line for location of two mounting holes
1
using dimensions shown in the chart and illustration
below. Additional wall framing is recommended in this
location. If wall framing is not available, the use of wall
anchors is recommended. Install the mounting screws
so there is approximately
head and wall. Position the two mounting brackets for
the chimney flue, then install using two mounting screws
per bracket. Refer to the illustration below.
MOUNTING LOCATION
SCREW LOCATION
Black Hood
Stainless Hood
Glass Hood
CEILING
3 /4
"
(19)
1 /16
17 "
(433)
1 /8
9 "
(232)
A
BOTTOM OF HOOD
Mounting location.
|
6 Wolf Customer Care 800.222.7820
1 / " gap between the screw
(6)
4
3
12 / "
(324)
4
16 3 / "
(416)
8
12 9 / "
(319)
16
Place the mounting tabs over the mounting screws. Use
2
the leveling adjustment screws to ensure the hood is
level. Refer to the illustration below.
Mount the electrical plate to the wall using screws
3
provided.
Place the backdraft damper on the round discharge then
4
install 6" (152) round metal ducting (not provided) to the
damper and seal with aluminum tape.
Make wiring connections. Refer to page 9.
5
Once wiring connections are complete, secure the upper
6
chimney flue to the mounting brackets using screws
provided. Refer to the illustration below. Place the lower
chimney flue over the upper, then lower until it rests on
the hood.
A
LEVELING
SCREW
Mount and level hood.
MOUNTING
TAB
Install telescopic flue.