Table of Contents
Advertisement
SERVICE INSTRUCTIONS
Repairing a flat tyre
ATTENTION: Explosion hazard!
There is considerable pressure in the tyre. Danger of injury! Parts can be thrown out and
injure you if you do not evacuate all the air from the tyre.
• Press the release pin in the valve inwards and evacuate all the air from the tyre.
•
Unscrew the valve cap.
•
Let the air out of the tyre completely by pressing the
pin in the centre of the v
•
Use the Allen key to remove the 5 cheese-head
screws (rear side of the wheel, 2).
•
Remove the rim halves from the shoe.
•
Remove the hose from the contact surface.
•
Repair the hose and re-fit or fit a new hose.
PLEASE NOTE
If it is intended to repair and re-fit the old hose and this has become wet during repair work, it
can simplify fitting if some talcum powder is applied to the hose.
•
Re-fit the rim halves into the shoe from the outside.
•
Fill the hose with some air.
•
Re-fit the cheese-head screws and screw the rim together tightly. Make sure the inner tube
does not get pinched between the rims halves!
•
Check the exact fit of the contact surface.
•
Pump up the tyre to the prescribed air pressure.
•
Re-check the exact fit of the contact surface.
•
Screw on the valve cap.
•
Fit the wheel.
100
alve in.
®
Invacare
- G50
Advertisement
Table of Contents
