Advertisement
Fig. #8
4. Tightly secure retractable guard in place using self
threading #8-10 x 9/16" long pan head plasform
screw and a flat washer as shown in Fig. #9.
5. Swing 9uard a few times in the direction of arrow
to see that it retracts out freely by itself and returns
to its normal position over the router table hole. See
Fig. #9.
Unitized Fence
3/16" l.D. x 1/2" O.D.
Flat Washer
6
2. Orient the retractable guard as shown in Fig. #7.
Position and hold the spring over its hub such that
formed end of spring wraps over the guard as
shown in Fig. #7.
Straight Leg
Spring
3. While holding the spring over the hub and formed
end over the guard, position and press the straight
leg of spring against surface 'X' to align hole in hub
over boss on unitized fence (see Fig. #8). Slip the
guard over the boss. Spring will now be trapped
between the guard and the fence. (Spring diameter
is bigger than the hub diameter. You will need to
use both hands to hold spring in proper position).
Straight Leg of Spring
. Surface 'X'
NOTE: If the guard does not retract o
riy,
loosen screw just enough unt]
es
retract out freely and snaps bc
nor-
mal forward position by itself.
6. Turn the unitized fence right side up.
ATTACHMENT OF UNITIZED FENCE ASSEYTO
TABLE
ALWAYS UNPLUG ROUTER BEFORE A1TACNG
FENCE TO AND REMOVING FROM TABLE
1. Assemble unitized fence assembly t
e as
shown in Fig. #10.
1/4-20
Large Knob
9/32" l.D. x 3/4" O.D.
Flat Washer-...
Slot
Retractable Guard
Router
Fig. #10
2.. Insert one of the 1/4-20 x 1 3/4" long hex headbolts
through the hole in the table top (from the under-
side) and the slot in the fence.
3. While holding the head of the bolt in the hex recess
on the underside of the tabletop, place a flat washer
over the bolt and install a large 1/4-20 knob onto
the bolt to loosely secure the fence.
4. Repeat for, the other slot.
NOTE: The unitized fence assembly can be
attathed to table with either side facing the
front To use other side, just remove the
kacbs and turn the fence around.
ASSEMY OF P13S14 BLOCK
Screw tie srraU end of clamp rod into threaded
ap rate until the plate bottoms on its
(make sure clamp plate is oriented such
tteC' is facing outwards as shown in Fig.
Advertisement
