Canon iPF8000 series Service Manual page 45

Setting Item
[System Setup] [Erase HDD
Data]
[Output Method] [Print]
[Print After Recv]
[Save: Shared Box]
[Take-up Reel] [Use Take-up Reel]
[Auto Feed]
[Skip Take-Up Err]
[Prep.MovePrint [Level 1]
er]
[Level 2]
[Level 3]
[Admin. Menu] [Change Password]
[Init.Admin.Pswd]
[Printer Info] [Paper Info]
[Ink Info]
[Head Info]
[System Info]
[Error Log]
[Other Counter]
T-1-20
[High Speed] Delete the file management information of the saved data in the HDD.
[Secure High Overwrite the random data in the whole of the hard disk drive.
Spd.]
[Secure] Overwrite 00 and FF and random data in the whole of the hard disk drive once at a time.
Execute the verify check whether the data has written correctly to the hard disk drive.
Select the output method of jobs sent from software other than the printer driver. This can be
set from the printer if you are using a printer driver.
[Print (Auto
Select [Print] to print normally. Select [Print (AutoDel)] to print and delete the data in hard
Del)]
disk. Select [Save: Box XX] to save to box without printing.
[Save: Box XX]
Setting of jobs sent from software other than the printer driver. This can be set from the printer
if you are using a printer driver. Select [On] to print after saving.
Select [Off] to print without saving to a common box.
Choose Enable to use the Media Take-up Unit.
This command is available only if Take-up Reel is set to Enable. Choose Yes to advance roll
paper automatically on the Rewind Spool, up to the fastening position.
Choose On to continue with printing even if an error occurs with the Media Take-up Unit.
Choose Off to have the printer pause before printing if a rewinding error occurs.
Select when moving the printer. Follow the instruction on the screen and perform the necessary
process.
This is not displayed when displaying a warning message about the amount remaining
maintenance cartridge.
Set a password to restrict displaying/setting of menus as follows. Allowed value is from 0 to
9999999.
- Allow only administrator to display/set
[IPv4]
[Change Password]
[Init.Admin.Pswd]
- Allow administrator to display/set and non-administrator to display only
[Interface Setup](exclude [IPv4])
[Date & Time]
[Date Format]
[Time Zone]
[Use RemoteUI]
[Reset PaprSetngs]
[Save: Shared Box]
Press [OK] to return the [Administrator Menu] password to factory default.
Indicates the current paper size, type, and related printer settings.
Indicates ink levels and maintenance cartridge capacity.
Indicates information about the printhead.
Indicates the firmware version, serial number, and interface information.
Indicates the most recent error messages (up to five).
Indicates the total printing volume of the printer.
Description/Instructions
Chapter 1
1-31