Pan & Tilt Limit Adjustment - JVC DPT 115 Operation Manual

3.3.2 Pan & Tilt Limit Adjustment
The pan & tilt head has separate adjustments for limiting pan-left, pan-right, tilt-up and tilt-
down. The adjustment of these limits are described below.
NOTE: These adjustments are to be made after the controller has been interfaced to the DPT
115. The controller will allow one to move the pan & tilt head and check the pan & tilt limits.
Pan Adjustment
Video from
Camera
Video Output
VIEW A
maximum travel by ESI.
2/12/05
View A illustrates the location of the pan limit
adjustments on the trunnion. To adjust the limit of pan
Tilt Vertical
Position Keys
travel, loosen the "Right Pan Limit Adjustment" screw
and rotate the pan-right limit block to the desired
position. Loosen the "Pan-Left Limit Adjustment screw
Camera
and rotate the pan-left limit block to the desired
Mounting
Adjustment
position.
Pan Limit
Switch
With the controller power "ON", move the joystick in the
Adjustment
pan position. Check the pan-right travel and the pan-left
travel. If either limit is still not adjusted properly, repeat
the adjustments described above.
NOTE: The pan limit switch adjustments are set at their
8
Document D0153