KVH Industries M7 Installation Manual page 30

A Wiring 3+ Receivers
To connect three or more receivers to a system
configured for Sky Mexico, follow these steps to
install a Spaun model SMS 5602 NF multiswitch
(KVH part #19-0413) between the grounding
block and the receivers, as shown in Figure 45.
1. Connect an RF cable from the "RF1"
connector on the grounding block to the
"H/High" (Horizontal High) connector on
the multiswitch.
2. Connect an RF cable from the "RF2"
connector on the grounding block to the
"V/High" (Vertical High) connector on the
multiswitch.
3. Set the multiswitch's LNB knob to "22 KHz."
At this setting, the multiswitch will provide a
constant 22 KHz tone to the antenna's LNB.
4. Connect the receivers to the individual
outputs of the multiswitch.
5. Connect the receivers to the customer's TVs.
32
Sky Mexico Systems
Figure 45: Multiswitch Wiring - Sky Mexico
RF2 RF1
Grounding
Block
RF2 RF1
Terr V/Low
Multiswitch
Receivers
1 2
AC Power In
100-240 VAC
50-60 Hz
Ground Wire
Vessel
AC Ground
H/Low V/High H/High
LNB
22 KHz
18V
3 4 5 6
Receiver #4
Satellite In
TV ANT/CABLE IN
R L
OUT TO TV
SATELLITE IN AUDIO VIDEO S-VIDEO PHONE JACK
Receiver #3
Satellite In
TV ANT/CABLE IN
R L
OUT TO TV
SATELLITE IN AUDIO VIDEO S-VIDEO PHONE JACK
Receiver #2
Satellite In
TV ANT/CABLE IN
R L
OUT TO TV
SATELLITE IN AUDIO VIDEO S-VIDEO PHONE JACK
Receiver #1
Satellite In
TV ANT/CABLE IN
R L
OUT TO TV
SATELLITE IN AUDIO VIDEO S-VIDEO PHONE JACK
12V