Table Of Contents; Technical Support - KVH Industries M7 Installation Manual

TracVision
MultiSat Control Panel (MCP) Configuration
These instructions explain how to install the TracVision M7 satellite TV antenna system on a
vessel. Complete instructions on how to use the system are provided in the User's Guide.
Installation Steps
1. Inspect Parts and Get Tools ................. 3
2. Plan the Antenna Installation .............. 4
3. Plan the Belowdecks Installation ........ 5
4. Prepare the Belowdecks Sites .............. 6
5. Prepare the Antenna Site...................... 7
6. Remove the Restraint ............................ 8
7. Wire the Antenna .................................. 9
8. Mount the Antenna ............................. 10
9. Wire the Switchplate ........................... 11
Who Should Install the System?
To ensure a safe and effective installation, KVH recommends that a KVH-authorized marine
technician install the TracVision antenna. KVH-authorized technicians have the tools and
electronics expertise necessary to install the system. To find a technician near you, visit
www.kvh.com/wheretogetservice.
Linear vs. Circular Systems
The installation process differs slightly depending on the type of LNB (low noise block) that is
installed in the antenna (linear or circular). These differences are noted throughout this manual.
Appendix B on page 33 notes the satellites available for each LNB type and geographic region.

Technical Support

If you need technical assistance, please contact KVH Technical Support:
North/South America, Australia:
Phone: +1 401 847-3327
E-mail: techs@kvh.com
(Mon.-Fri., 9 am-6 pm ET, -5 GMT)
(Sat., 9 am-2 pm ET, -5 GMT)
KVH, TracVision, and the unique light-colored dome with dark contrasting baseplate are registered trademarks of KVH Industries, Inc.
All other trademarks are property of their respective companies. The information in this document is subject to change without notice.
No company shall be liable for errors contained herein. © 2007-2011 KVH Industries, Inc., All rights reserved. 54-0417-02 Rev. D
M7 Installation Guide
®
10. Wire the MCP and Receivers.............. 12
11. Connect Power ..................................... 14
12. Mount the Switchplate & MCP .......... 15
13. Turn On the System............................. 16
14. Choose an Operating Mode................ 17
15. Select Satellites...................................... 18
16. Set the LNB Skew Angle ..................... 24
17. Run a Check Switch Test..................... 25
18. Educate the Customer ......................... 27
Europe, Middle East, Asia:
Phone: +45 45 160 180
E-mail: support@kvh.dk
(Mon.-Fri., 8 am-4:30 pm, +1 GMT)
1