Error Codes; Electrolux Icon 36" Induction Cooktop Error Codes Table - Electrolux E36IC75FSS Service Manual

The electronic components in the induction cooktop have built in error codes to assist in the accurate
diagnosis and repair of the unit in the event of failure. The chart found on pages 30 - 32 provides a list
of the error code numbers as well as the likely cause and suggested corrective action.
When an error code is displayed the letter "E" will be displayed in the
cook zone touch control LEDs (Fig. 8) and the error code number will
be displayed in the main touch control timer LED.
See the example at right.
ELECTROLUX ICON 36" INDUCTION COOKTOP ERROR CODES
Error Possible Cause or Condition
2 LF zone control defective
3 LF zone control defective
4 LF zone control
6 LR zone control defective
7 LR zone control defective
8 LR zone control
10 Center zone control defective
11 Center zone control defective
12 Center zone control
14 RR zone control defective
15 RR zone control defective
16 RR zone control
17 RF zone control
18 RF zone control
19 RF zone control
21 Timer key sensor defective
22 Timer key sensor defective
23 Keep warm key sensor defective
24 Lock key sensor defective
25 Main power key sensor defective
30 AC input voltage too high at the 3 cook zones
70 induction module.
31 Internal generator error, sync in the 3 cook zones
induction module / left side cooking zones.
NOTE: If multiple changing error codes are displayed check for disconnected wires or cables.
TROUBLESHOOTING AND DIAGNOSIS

Error Codes

key sensor
key sensor
key sensor defective
key sensor
key sensor
key sensor defective
key sensor
key sensor
key sensor defective
key sensor
key sensor
key sensor defective
key sensor defective
key sensor defective
key sensor defective
Induction Cooktop Error Codes continued on next page
Page 29
Suggested Corrective Action
- Test cables and connections between left side cook
zones control and main power control.
- Replace left side cook zones touch control
- Test cables & connections between center/right rear
cook zone control and main power touch control.
- Replace center/right rear cook zone control touch
control
- Test cables & connections on main power/right front
cook zone touch control.
- Replace main power/right front cook zone touch control
-Verify AC input voltage at the cooktop input.
-Verify AC main input cables, screws and jumpers.
-Replace the fi lter board in the 3 zones induction module
-Test cables & connections on left side generator circuit
board (dual).
-Replace the generator circuit board (LF/LR) in the 3
zones induction module