COMPONENT ACCESS AND SERVICE PROCEDURES
Filter Board Replacement (Two Cook Zone Module)
To remove and replace the fi lter board in the
L1 (Black)
L2 (Red)
two cook zones module loosen the strain relief
Ground (Green)
retainer screw and remove the black strain relief.
Disconnect the L1, L2 & Ground supply wires from
the push on terminals (Fig 26).
Strain Relief
Fig. 26
Carefully unplug the remaining wires and
connectors. Remember to use the special cable
removal tool on the fl at ribbon connector at terminal
X58 (Fig 26A).
X58
Fig. 26A
Depress the locking tabs on the right side of the
fi lter board to release the board from the housing
(Fig 26B).
Depress
Locking
Tabs
Fig. 26B
Page 26