Cookingzone Heatsfood Toohot Or Not Enough; Fooddoes Not Heat Evenly; Poorcookingresujts; Cooktopzonecontroldisplaysan Error Code - Electrolux EW36IC60I - 36 in. Induction Cooktop Use And Care Manual

Solutions to Common Problems
COOKmNG ZONE H_TS FOODTOO HOT OR NOT HOT ENOUGH
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
• Incorrect power level setting. Adjust the power level setting higher or lower and refer
to recipe for guidance and adjust accordingly.
FOOD DOES NOT HEAT EVENLY
_ [] [] [] _ [] [] _ [] [] [] [] [] [] [] [] [] [] [] [] [] []
• Lightweight or warped pans were used. Be sure to use good quality cookware.
• Use only flat bottom, evenly balanced medium or heavyweight cookware. Heavy and
medium weight pans heat evenly. Because lightweight pans heat unevenly, foods may
burn more easily (See pages 9 to 11 for further information).
• Adjust Cooking Zone power level setting until the proper amount of heat is obtained.
POORCOOKINGRESULTS
_ [] [] [] _ [] [] _ [] [] [] [] [] [] [] [] [] [] [] [] [] []
• Many factors affect cooking results. Adjust the recipe's recommended power levels or
. cooking times.
Cookware is too lightweight or warped. Use heavier quality cookware so foods being
prepared may cook more evenly.
COOKTOP ZONE CONTROLS DmSPLAYERROR CODE
[] .[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
If an error occurs that affects a zone, that zone will display an error and that specific zone
will shut down. If the error affects more than one zone but a single Induction Heater,
then the zones affected by that Induction Heater will display an error and those specific
zones will shut down. However if an error occurs that affects the whole cooktop, then
the error will display in all zones and the whole cooktop will shut down. If any error
occurs try shutting power down to the cooktop then reapply power. If the error persists
then call Electrolux 1-877-4ELECTROLUX (1-877-435-3287).
cooK .G zo.Es E..ER LED co .uousLY
ROTAT,NGAROUND D,G_TALD,SPLAY, , , , , ,
• Induction Cooktop pan detection sensors do not see the correct cookware. Test with a
. magnet to be sure cookware is made with Induction compatible material.
Cookware has been removed from the Cooking Zone without turning the Cooking Zone
OFF. Place cookware back on to the Cooking Zone or if finished cooking turn OFF the
. affected Cooking Zone.
Cookware is not centered over the Cooking Zone properly. Refer to page 10 for correct
cookware placement.