Prepare Boiler Location - Weil-McLain Gold CGi Series 2 User Manual

GOLD
1a
Prepare boiler location —
Installations must
follow these codes:
Before locating the boiler,
check the following:
6
CGi Series 2 Gas-Fired Water Boiler
• Local, state, provincial, and national codes, laws, regulations and
ordinances.
• National Fuel Gas Code, ANSI Z223.1–latest edition.
• Standard for Controls and Safety Devices for Automatically Fired
Boilers, ANSI/ASME CSD-1, when required.
• National Electrical Code.
• For Canada only: B149.1 or B149.2 Installation Code, CSA C22.1
Canadian Electrical Code Part 1 and any local codes.
• Check for nearby connection to:
• Check area around boiler. Remove any combustible materials, gasoline
and other flammable liquids.
• Boiler must be installed so that gas control system components are
protected from dripping or spraying water or rain during operation
or service.
• If new boiler will replace existing boiler, check for and correct system
problems, such as:
codes & checklist
The CGi boiler gas manifold and controls met safe
lighting and other performance criteria when boiler
underwent tests specified in ANSI Z21.13–latest
edition.
• System water piping
• Venting connections
• Gas supply piping
• Electrical power
Failure to keep boiler area clear and free of combustible
materials, gasoline and other flammable liquids and
vapors can result in severe personal injury, death or
substantial property damage.
1. System leaks causing oxygen corrosion or section cracks from
hard water deposits.
2. Incorrectly-sized expansion tank.
3. Lack of antifreeze in boiler water causing system and boiler to
freeze and leak.
Part Number 550-110-710/0200