JVC LYT0291-001B Instructions Manual page 70

70
EN
SYMPTOM
20. The Picture Wipe and Dissolve
functions do not work.
21. The Picture Wipe function
does not work.
22. Scene transition does not go as
expected.
23. The Video Echo mode does
not work.
24. Even when Slow Shutter is not
selected, the image looks like
it is activated.
25. There is no strobe when the
Classic Film or Strobe mode is
activated.
26. White Balance cannot be
activated.
27. When shooting a subject
illuminated by bright light,
vertical lines appear.
28. When the screen is under
direct sunlight during shooting,
the screen becomes red or
black for an instant.
TROUBLESHOOTING
POSSIBLE CAUSES
20. • The last selected editing scene is
ending.
• At the end of the last selected
scene for editing, the Power
Switch was set to "OFF".
• The power is off.
21. • The Slow Shutter mode is
activated.
• The Squeeze or Cinema mode is
selected in the Recording Menu.
22. • When using "Picture Wipe/
Dissolve" ( pg. 34) or
"Dissolve during 5 second
mode recording" (
there is a delay of a fraction of a
second between the previous
record stop-point and the
Dissolve start-point. This is
normal, but this slight delay
becomes especially noticeable
when shooting fast-moving
subject or during rapid panning.
23. • The Picture Wipe or
Dissolve functions are in use.
• The Squeeze mode is selected in
the Recording Menu.
• A Fade-In or Fade-Out is in
progress (White Fader, Black
Fader or Black & White Fader).
• Dissolve during 5-second mode
recording is in use.
24. • When shooting in the dark, the
unit becomes highly sensitive to
light and the image takes on an
effect similar to Slow Shutter.
25. • The Picture Wipe or Dissolve
function is in use.
• Dissolve during 5-second mode
recording is in use.
26. • The Sepia or Monotone mode is
activated.
27. • This is a result of exceedingly
high contrast, and is not a
malfunction.
28. • This is not a malfunction.
CORRECTIVE ACTION
20. • Select Picture Wipe or Dissolve
before beginning recording. The
effects are then automatically
activated (
• Do not turn off the camcorder's
power after setting Edit-In and
Edit-Out points, as they will all
be erased (
• The camcorder automatically
shuts off after 5 minutes have
elapsed in the Record-Standby
mode. Make sure you continue
operations within 5 minutes
after engaging Record-Standby
mode (
21. • Make sure the Squeeze mode,
Cinema mode, or Slow Shutter
mode is not activated when
preparing to use the Picture
Wipe function (
22.
pg. 23),
23. • Make sure the Squeeze mode is
set to "OFF" (
• Do not try to use the Video
Echo mode during a Fade-In or
Fade-Out or when Dissolve is
activated during 5-second mode
recording (
24. • If you want the lighting to look
more natural, set GAIN UP to
"AGC" or "OFF" in the
Recording Menu (
25. • Do not try to use the Classic
Film or Strobe mode during a
scene transition (
34).
26. • Turn off Sepia or Monotone
before setting White Balance
(
27.
28.
(cont.)
pg. 34).
pg. 34).
pg. 34).
pg. 31, 37).
————
pg. 35).
pg. 33).
pg. 31).
pg. 23, 33,
pg. 36).
————
————