Dolmar PS-6400 Repair Manual page 33

0 9 VIBRATION DAMPER / TUBULAR HANDLE
(5.0 Nm ± 0.5)
4
(7.5 Nm ± 0.5)
Repair Manual PS-6400/PS-7300/PS-7900
1
2
(6.0 Nm ± 0.5)
(7.5 Nm ± 0.5)
4
(7.5 Nm ± 0.5) (5.0 Nm ± 0.5)
Damping system
Vibration damping using the DOLMAR 2-mass
system (D2M).
Spring 1 tubular handle/cylinder is attached with Torx
screw 2 (M6 x 14).
Replace forward clutch-side spring 3 (038.114.130)
complete with screw and cap.
Rear clutch-side spring is fastened with Torx screws
4 (M5.5 x 20) (small screw head).
Removing and reinstalling the spring caps
First loosen the inside Torx screws, then unscrew
the caps with 10 mm Allen key.
If the Allen key is overwinging, spray the cap with
ice spray and try it again.
To assemble, first tighten the caps to 7.5 ±0.5 Nm,
then tighten the Torx screws to 5 ±0.5 Nm.
(5.0 Nm ± 0.5)
Tool
3
33