Honda HS624 Dealer Instructions page 8

HS624 • HS724 • HS828 • HS928 • HS1132 SNOWBLOWERS
2. Install the caps on the ends of the two handlebar
mounting struts.
3. Attach the handlebar assembly.
All except the HS724 track-type:
a. Install the handlebar on the struts, and insert
the two 8 x 41 mm saddle-head bolts from
the outside, as shown.
Be sure all control cables are placed on
the inner side of the handlebars and
struts (see below).
b. Install the 8 mm curved square washer and
8 mm flange nut on the left handlebar
mounting strut.
Do not install the washer and nut on the right
handlebar mounting strut until step 7.
HS724 Track-type only:
a. Install the handlebar on the struts, and insert
the three 8 x 41 mm saddle-head bolts from
the outside.
Be sure all control cables are placed on
the inner side of the handlebars and
struts (see below).
b. Install the three 8 mm curved square washers and three 8 mm flange nuts on the left and right lower
handlebar mounting strut except the right upper bolt.
Do not install the washer and nut on the right upper handlebar mounting strut until step 7.
c. Tighten the 8 mm flange nut to the specified torque.
TORQUE: 22 N•m (16 ft-lb)
THROTTLE CABLE ROUTING
TRANSMISSION
RESERVOIR
THROTTLE CABLE
8 of 17
LEFT-SIDE HANDLEBAR
AND STRUT
CHOKE CABLE
LEFT-SIDE (HS1132 ONLY
HANDLEBAR
AND STRUT
SHIFT
CABLE
8 x 41 mm SADDLE-
HEAD BOLT (2)
8 mm CURVED
SQUARE WASHER (2)
8 mm FLANGE NUT (2)
MOUNTING STRUTS
HS724 TRACK-TYPE ONLY
CAP (2)
8 mm
FLANGE
NUT (3)
8 mm CURVED
SQUARE WASHER (3)
ENGINE STOP
SWITCH WIRE
CAP (2)
8 x 41 mm SADDLE-
HEAD BOLT (3)
RIGHT-SIDE HANDLEBAR
AND STRUT
AUGER
CLUTCH
CABLE
DRIVE
CLUTCH
CABLE
CHUTE GUIDE LEVER CABLE